Hi fellow simmers.
After a lot of research I finally ended up with FDS to be my cockpit software of choice. The decision was taken last year and the I started the first small steps to build somthing 737'ish.
I have used the most of my sim slots this year fabricating parts for the sim but have done some softwaretesting and configuration last week now after the core and CPFlight license was bought.
Will update post as new parts are added and until further development from FDS, I use FSXpand for eicas/flaps due to missing standby instruments in FDS. I know these will come in a later release and looking forware to show off a 100% FDS cockpit down the road sometime. The parts fabricated is yoke, touchscreen and gearhandle.
One pic as for now: